Record-Arm the Track that contains the ReWire ClientĪrming the Track synchronizes the Client application to REAPER. To check that audio is getting from the Client application to REAPER, load a Project into the Client application, and use either of the following methods to test playback: The Main Mix output from the Client application will be automatically routed to the Track you have just used to start the ReWire session. Routing AUDIO from the Client application to REAPER The application you have selected will now load. Select the application you wish to use, then select OK. REAPER will display a list of the ReWire equipped applications that are available on your system. Select ReWire from the FX plug-in list.ģ. Click on the FX button of the Track that will host the ReWire application.Ģ. If you are planning to use ReWire to open an existing Project in the Client application, you should open the Client application and note the Tempo of the Project before running a ReWire session.ġ. When you launch a ReWire session, the Client application will automatically adopt the Tempo of the Host application. NOTE: The Tempo of the ReWire Host sets the Tempo of both applications. The Client receives and sends signals via the Host application. In a ReWire session, the first application acts as the Host, and the second application acts as the Client. Audio and MIDI data are transferred between the two applications in real-time, allowing you to use the features in each application as if they were one. ReWire is a technology developed by Propellerhead Software that allows applications to share audio, MIDI and synchronization data. 4.1 To route a MIDI Track from REAPER to the Client application.4 Routing MIDI from REAPER to the Client application.3.1 To enable multiple audio outputs via a ReWire session.Insert an 'Empty Event' in the REAPER Project Record-Arm the Track that contains the ReWire Client 2 Routing AUDIO from the Client application to REAPER.

Rewire software